Paul, I moved the discussion to the correct group. :)
I had a neogeo board that did the same thing. It was a thermal
related problem. The way I found it out is, go and get some freon or
component cooler. When the machine finally comes up, start spraying each
chip with the freeze spray. Hopefully the machinie will fail and you can
narrow down the chip.
Not scientific, but works well enough for me. :)
Good luck,
Steve
---------------------------------------------------------------------------
** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
** message body to rasterlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Tue Jun 20 20:19:41 2000
This archive was generated by hypermail 2.1.8 : Tue Dec 02 2003 - 17:28:58 EST