Re: Source for 2114 ram (pac man)

<x-flowed>
Would recommend you continue your search...unless you check the schematic
and the specs there allow for 300ns devices.

John :-#)#

At 12:31 AM 2/19/2001, you wrote:
>Ok one more question. I have found a source of 300NS rams. The boards used
>200ns. Is the timing that tight or can I get away with using the 300ns
>parts?
>
>Sure hope so as I found them for $1.49 each :)
>
>David
>----- Original Message -----
>From: Neil Bradley <neil@synthcom.com>
>To: <rasterlist@synthcom.com>
>Sent: Sunday, February 18, 2001 11:47 PM
>Subject: Re: RASTER: Source for 2114 ram (pac man)
>
>
> > > Well now I just need a good source of apple II's...
> > > :)
> > > Ideas?
> >
> > eBay:
> >
> > http://cgi.ebay.com/aw-cgi/eBayISAPI.dll?ViewItem&item=1215625924
> > http://cgi.ebay.com/aw-cgi/eBayISAPI.dll?ViewItem&item=1215912640
> > http://cgi.ebay.com/aw-cgi/eBayISAPI.dll?ViewItem&item=1214919853
> >
> > The going rate for them seems to be in the $40-$60 range - not a bad
> > dealif you get a 48K unit with 24 chips! Sure beats the butt slamming
> > prices that they'd cost new!
> >
> > -->Neil
> >
> > --------------------------------------------------------------------------
>-----
> > Neil Bradley Mechanical engineers build weapons. Civil
>engineers
> > Synthcom Systems, Inc. build targets.
> > ICQ #29402898
> >
> >
> >
> > --------------------------------------------------------------------------
>-
> > ** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in
>the
> > ** message body to rasterlist-request@synthcom.com. Please direct other
> > ** questions, comments, or problems to neil@synthcom.com.
> >
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
>** message body to rasterlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
** message body to rasterlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.

</x-flowed>
Received on Mon Feb 19 08:23:55 2001