Re: I, Robot joystick inversion

This is not a digital output. You would need some nature of analog
inverter.
Have to look at my docs but I would expect that you could swap the wires
much as you can with a pot based analog controller.

----- Original Message -----
From: "Tom McClintock" <tomm@mgcap.com>
To: <rasterlist@synthcom.com>
Sent: Sunday, March 10, 2002 10:10 AM
Subject: RASTER: I, Robot joystick inversion

> I'm swapping out my I, Robot joystick with one of the
> 'newer' Hall Effect joysticks (circa 1989). However,
> the orientation of the hall-effect pcb is such that I
> cannot fit the control panel with joystick onto the
> cabinet. The hall-effect pcb sticks out about an inch
> too much.
>
> I can, however, rotate the joystick 180 degrees and
> everything fits just fine. This also has the
> challenging effect of inverting my controls - down is
> up, and left is right.
>
> Is my best solution to wire up a 7404 hex inverter for
> the X and Y joystick outputs, or is there something
> else I am missing?
>
>
> tm
>
>
> --------------------------------------------------------------------------
-
> ** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in
the
> ** message body to rasterlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
>

---------------------------------------------------------------------------
** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
** message body to rasterlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Mon Mar 11 02:24:20 2002