Sorry , when I read that the first time I over looked the "missing"
I'll get back to you on which wire is the base and which is the emitter
Sean McLachlan wrote:
> I need to replace a missing HOT on a GO7, but I don't know which wire to
> solder to which pin. Apparently I can't read schematics. My chassis has
> red and a brown wires. Which one goes where? And if you want to school me
> a little on the proper terminology, that's fine too. :)
>
> Thanks, guys. And thanks to Neil for maintaining these lists for the last
> couple years. Best signal to noise ratio of any large list I have ever
> seen.
>
> Sean McLachlan
> MIS Manager
> LithoFlexo grafics inc.
> 801.484.8503
>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
> ** message body to rasterlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
** message body to rasterlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Mon Jun 16 22:16:58 2003
This archive was generated by hypermail 2.1.8 : Tue Dec 02 2003 - 17:51:33 EST