Re: Re: WG K4600 monitor problem

In addition to the cap kit, I'd also pull the small video PCB and look for bad solder joints at the sync pins.

Of course, most of the 4600s also have a ton of bad solder joints everywhere, anywhere you find header pins, the solder joints should be reflowed.
HTH,

James H.

>
> From: solarfox@texas.net
> Date: 2003/11/09 Sun PM 11:06:32 CST
> To: rasterlist@vectorlist.org
> Subject: Re: RASTER: WG K4600 monitor problem
>
> On Sun, 9 Nov 2003 18:21:25 -0500 (EST), you wrote:
>
> >I hadn't because it really looked like more was wrong. But adjusting the
> >horz hold now, I can stop the rolling, but the picture is skewed sideways.
> >After some time it starts to roll and I have to adjust again -- and the
> >slant tilted the other way.
>
> Do a full recap on it (i.e. change out all the electrolytic
> capacitors). Odds are pretty good that'll fix it.
> -----------------------------------------------------------------------------
> "In ancient times, they believed that there were only four kinds of matter:
> Earth, Water, Air, and Fire. Nowadays, of course, we know that there are
> actually four states of matter: Solid, Liquid, Gas, and Plasma. Thank God
> for progress!" ---(Kelvin Throop III)
> -----------------------------------------------------------------------------
> solarfox@DON'TMESSWITHtexas.net (Gary Akins jr.)
> http://lonestar.texas.net/~solarfox
> -----------------------------------------------------------------------------
>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
> ** message body to rasterlist-request@vectorlist.org. Please direct other
> ** questions, comments, or problems to chris@westnet.com.
>

---------------------------------------------------------------------------
** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
** message body to rasterlist-request@vectorlist.org. Please direct other
** questions, comments, or problems to chris@westnet.com.
Received on Mon Nov 10 06:52:03 2003