RE: Mad Planets factory jumpers

That is what I had figured, I was hoping someone on the list could confirm this one way or another.

JB

-----Original Message-----
From: owner-rasterlist@vectorlist.org [mailto:owner-rasterlist@vectorlist.org] On Behalf Of Tom McClintock
Sent: Thursday, March 11, 2004 9:04 AM
To: rasterlist@vectorlist.org
Subject: Re: RASTER: Mad Planets factory jumpers

Although a bit of a leading question I'm sure, I would presume the
wire-wrap jumpers are the same as the 'third' version of the Q*Bert PCB
as Mad Planets was put into production during the end run of Q*Bert.
Here's the RAM jumper data from the schematics:

-----------------
RAM Jumpers: (these are zero-ohm resistor jumper wires)
Mad Planets: JP3; JP2; JP8; JP5

Background ROM/RAM Jumpers: (these are generally blue plastic jumper tabs)
Mad Planets: JP9; JP10
------------------

Joe wrote:

> What jumper wires were on the Gottlieb Mad Planets main boards from the factory?
>
> Thanks,
> JB
>
> ---
> Outgoing mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.600 / Virus Database: 381 - Release Date: 2/28/2004
>
>
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to chris@westnet.com
>
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com

---
Incoming mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.600 / Virus Database: 381 - Release Date: 2/28/2004
 
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.600 / Virus Database: 381 - Release Date: 2/28/2004
 
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com