Re: Zaxxon Electrohome Troubleshoot

-----Original Message-----
From: Dustin Holden <discuspro@yahoo.com>
To: rasterlist@vectorlist.org
Date: Sat, 3 Nov 2007 10:20:29 -0700 (PDT)
Subject: RASTER: Zaxxon Electrohome Troubleshoot

>
> I've recently finished a cap kit on my Zaxxon's
> electrohome G07. I did the optional C303 upgrade.
> I've triple checked that all the capacitors are in the
> right places, their polarity, and if there are any
> cold solder joints. To my eyes everything looks fine.
> Well I installed the board and now I get about 3/4 of
> the screen. I can actually see the picture, it just
> looks like it hits a wall 3/4 of the way across the
> screen, and where it hits the wall it is really
> intensely bright like everything is compressed into on
> line.
>

what did it do before you fitted the kit?
it may be a bad cap,
or a wrong cap - one of them should be non-polarised.

as for the other problem, the presets fail along the edge of the board - i replace them all.

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sun Nov 4 13:54:49 2007