Any chance I could have you open one up and look at the ground lead on the
twisted pin cable? I have an 8085 pod I tried to borrow the twisted pair
cable from and it has the shield ground tied to pin 20. That doesn't work
on the 8080 as that pin is +5. Ground should be tied to pin 2. I am
wondering how they did that I suspect it is in the potted UUT end as I don't
see anything on the connector end.
David
-----Original Message-----
From: owner-rasterlist@vectorlist.org
[mailto:owner-rasterlist@vectorlist.org] On Behalf Of Alex Yeckley
Sent: Wednesday, February 20, 2013 4:15 AM
To: 'David Shoemaker'; 'Technical Tools Mail List'; jrr@flippers.com;
rasterlist@vectorlist.org
Subject: RE: [Techtoolslist] RASTER: FW: Using 8080 pod on Midway 8080
boards (Space Invaders)
>Do your pods have the twisted cable or the straight? Both mine have
>the straight.
Our 8080 pods have the OEM twisted cables. Our 6502 pods (re: Clay's
Tempest question) come in both twisted and the flat cables. I'm assuming
the flat cable is a non-factory replacement item, but could be totally wrong
about that. The 6502 pod that failed just happened to have had a flat cable
but I'm confident the drive problem was unrelated; we found one specific
driver output that wasn't going sufficiently high once plugged into a "real"
target board. It wasn't a general malaise of the address lines like you
might expect from transmission line losses or higher EMI susceptibility due
to the flat cable if that's what you are wondering.
>Are you using a 9010 or a 9100 to drive the pod?
Both...
Alex
---- ayeckley@elektronforge.com www.elektronforge.com --------------------------------------------------------------------------- ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org ** Please direct other questions, comments, or problems to chris@westnet.com --------------------------------------------------------------------------- ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org ** Please direct other questions, comments, or problems to chris@westnet.comReceived on Thu Feb 21 22:56:23 2013
This archive was generated by hypermail 2.1.8 : Fri Feb 22 2013 - 09:50:01 EST