>Hit setup on the 9010, hit more until you get to 'set trap active
force line' set it to 'no' .. no >need to disable WD.
Assuming the reset signal is only used to reset the micro. If it goes
to other registers, etc you could run into problems getting the board
to run.
-Adam
====================
http://www.onecircuit.com
====================
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
Received on Sun Apr 24 18:05:52 2005
This archive was generated by hypermail 2.1.8 : Mon Sep 12 2005 - 19:58:50 EDT