<x-flowed>Then go into Setup and tell the 9100A to simply ignore the power supply...
John :-#)#
At 6:14 PM +0100 5/28/05, Phil Morris wrote:
>>If you have the extension socket (Instrument Accessory
>>#9000A-7201), then you can check the voltage(s) as connected to the
>>pod.
>
>Afraid I don't have that.
>
>>It is possible that you have a bad connection at the UUT socket,
>>isn't it? You have run the pod self test and wiggled the cable
>>while under self test?
>
>Tried all that - besides which, I've only just put a new CPU socket
>onto the N.D. board as it was impossible to plug the Fluke into the
>original socket.
>
>The 6502 CPU works fine in the new socket, but the Fluke 6502 pod
>won't (yet it works on other 6502-based boards). I'm sure the socket
>and contacts are fine.
>
>Phil
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
</x-flowed>
Received on Sat May 28 10:25:33 2005
This archive was generated by hypermail 2.1.8 : Mon Sep 12 2005 - 19:58:52 EDT