Re: Fluke 8088 pod and a moron...

Thanks for the reply - actually, it's the cable that goes from the 9010
base to the pod that I reversed inside the pod and is also the one that
wiggling seemed to allow the self test to pass. Are those available
anywhere or should I recrimp pins into the connector? I am assuming
they are different from pod to pod - is this a correct assumption as
well? As for rummaging through your extensive pile of spare parts, when
can I show up?

Thanks,
Greg

John Robertson wrote:

> Unlikely that reversing the cable would damage the pod. The inputs are
> ALL protected up to 15VDC as I recall. Rather it is far more likely
> that you simply have a bad cable. You can order one from Digi-Key -
> Single-Ended - Style 2 (or 4 depending on where you want pin 1) from
> CW Industries - the Canadian part number (hey I'm in Canada) is
> C2PXT-4018M-ND for an 18 inch one that you can then simply crimp on
> the 40 pin socket #CSR40T-ND (with strain relief).
>
> At least that's what I would do (after rummaging through my pile of
> pod spare parts (extensive)).
>
> John :-#)#
>
> At 6:23 AM -0700 12/9/05, voyager@galaxian.com wrote:
>
>> I received a Fluke 8088 pod yesterday and plugged it in to do a self
>> test to see if my 'untested' pod worked or not. Well the test
>> failed, but if I wiggled the cable at the pod side it seemed to pass
>> - so I pulled the case apart to look for loose connections or wires.
>> I looked at the cable connection that was a little lose, disconnected
>> it, plugged it back in and ran the test again to produce nothing at
>> all. Next, I realized the connector was on backwards - nice. Of
>> course, reversing it producing nothing but a failure worse than
>> before and wiggling the cable does nothing. Anyone done this yet that
>> has some info on how much damage it did to the pod? I could
>> troubleshoot it with another 8088 pod, but I do not have another...
>>
>> Greg
>
> _______________________________________________
> Techtoolslist mailing list
> Techtoolslist@flippers.com
> http://seven.pairlist.net/mailman/listinfo/techtoolslist
>
>

_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
Received on Sat Dec 10 13:21:48 2005