Re: Bytek Fireman 8x

Cameron Rector wrote:
> Hello all,
> I am new to this site, so I will applogize for dumb questions up front.
>
> I have a Bytek fireman 8x and I am having trouble programming
> TMS2532A's. The programming part goes well until verify. It seams that
> at address 0800h it fails. It does this on every chip I try. I don't
> know if this could be a configuration setting or it the unit has a bad
> solder joint or IC. I did a visual inspection from A11 pin 18 back
> through the circuit traces and joints, however I didn't find anything
> wrong. I tried to call Bytek and their phone is disconnected and my
> email bounced back.
>
> So, does anyone here know anything about this machine? Does anyone know
> where I can get the schmatic's for this programmer?
>
> I am a newbe at programming eproms, so don't overlook the fact I could
> have a software setting wacked out.
>
> The first verify error says "ADDS 0800h Ram 01 Device 00"

That's OK, the last address in a 2532 would be 07FF, so at 0800 you're
no longer inside the 2532.

You have the end of buffer set too high, otherwise it would have stopped
at 07FF.
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
Received on Sun Oct 1 19:05:33 2006