Hi Martin,
>From memory it was a mask programmed 804x series, I'd need to strip it
down again to be 100% sure.
Cheers
Chris
-----Original Message-----
From: techtoolslist-bounces@flippers.com
[mailto:techtoolslist-bounces@flippers.com] On Behalf Of Martin White
Sent: 19 November 2006 14:16
To: Technical Tools Mail List <techtoolslist@flippers.com>
Subject: Re: [Techtoolslist] Fluke 9010
Chris,
What's the cpu? The service manual shows "536094" but not too
sure if this is a Fluke part number or what? Is that the actual number
on the cpu?
Just read through some interesting stuff on the tape drives in
the service manual so I may open mine up at some point and see if I can
work out what's up with the drive. Used to work fine until it was stored
for a few months. When it came out of storage it no longer works. Never
really bothered about it too much since I have the RS232 option but it
would be nice to get it going again!
Martin.
On 19/11/06 12:47, "Chris Toseland" <Chris@muppzlab.co.uk>
wrote:
Hi folks,
This maybe a long shot but does anyone have or can
duplicate the controller CPU for the tape drive unit on a 9010?
My tape unit doesn't work, I've checked the sensors and
even tried driving the CPU input pins directly all to no avail so I and
can only assume that the CPU is dead.
Thanks
Chris
________________________________
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
--
Guddler's Domain
http://www.guddler.co.uk
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
Received on Sun Nov 19 09:49:43 2006
This archive was generated by hypermail 2.1.8 : Sun Nov 19 2006 - 10:50:01 EST