Re: Tweaking a 9010 z80 pod to be a z80b pod?

MCR board sets are peculiar things. I have had only limited success
using a 9010 with them. I found that most of the time a Run UUT simply
wouldn't work but occasionally it would. The chances improved when I
burnt my own set of ROMs. This was Tron incidentally. I think it had
something to do with the speed of the ROMs and the Z80CTC. I'd have to
find my test rom set to look up the speed of the roms that i ended up
using.

I seem to recall that I was able to do rom and ram tests ok.

I should probably point out that this is going back about 5 years now,
hence the slightly vague response!

Martin.

On 1 May 2009, at 09:17, mike@the-coates.com wrote:

> I can't think of any reason why it wouldn't work if you swopped the
> CPU in the pod for a B version, although I've obviously been lucky,
> my Z80 pod works fine at 6Mhz without me needing to do that.
>
> (I did however, replace the 12Mhz CPU with a 16Mhz one in my 68000
> pod)
>
> ---
>
> Trying to get a pair of spy hunter boards working. One is brain
> dead and I want to run it through the 9010 paces. But I don't have
> a z80b pod. Is it possible to mod a z80 pod to be a z80b pod?
> _______________________________________________
> Techtoolslist mailing list
> Techtoolslist@flippers.com
> http://seven.pairlist.net/mailman/listinfo/techtoolslist
> FTP site is: ftp://ftp.flippers.com/TTL/TestEquipment
> Archive site: http://seven.pairlist.net/pipermail/techtoolslist/

_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
FTP site is: ftp://ftp.flippers.com/TTL/TestEquipment
Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
Received on Tue May 5 14:03:32 2009