Re: Directory success !!! (for HDR that is.)

and another one comes through that was a reply to my reply that had the
full directory quoted below! hehhehe

(I trimmed it this time!)

Andrew Welburn
http://www.andys-arcade.com

On 12/12/2012 20:34, Martin White wrote:
> I started for centipede once. I think I got all the ICs in but got bored after only a small amount of the connections. And I never really properly grasped the dividing up into functional blocks and scripting for those blocks properly. I found it hard to apply the examples to my case.
>
> Sorry for the lack of punctuation. In a bar, using my phone :)
>
> -----Original Message-----
> From: Andrew Welburn
> Sent: 12/12/2012 20:15
> To: Technical Tools Mail List
> Subject: Re: [Techtoolslist] Directory success !!! (for HDR that is.)
>
> Because when you map a UUT (unit Under Test) netlist you need to tell it
> which part is in which location and how it is connected to every other
> IC on the PCB so that it can tell operators where to move in
> back-tracing a fault in GFI mode. (Guided Fault Isolation) Every device
> on the UUT needs describing, its I/O directions etc.. Fluke provides
> most TTL and basic discretes as you can see.

[snip!]
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
FTP site is: ftp://ttl.arcadetech.org
Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
Received on Thu Dec 13 11:13:51 2012