Re: Kurz-Kasch TC-590-89 Test Clip

-----Original Message-----
>From: John Robertson <jrr@flippers.com>
>Sent: Feb 22, 2013 7:42 PM
>To: Technical Tools Mail List <techtoolslist@flippers.com>
>Subject: Re: [Techtoolslist] Kurz-Kasch TC-590-89 Test Clip
>
>teeray wrote:
>> Anyone know how a Kurz-Kasch TC-590-89 Test Clip is wired ?
>> All I can find says it should have three test clips E4, B3, D3
>>
>> Thanks
>> Tim
>>
>> _
>
>
>These are part of the KK signature kit for 8080 boards. TC-590-89 is
>basically a 16 pin Glomper clip with jumpers:
>
>Part "EE Module" is a 40 pin header box that have only one jumper
>between pins 14, 16 & 24.
>Part "B-3" and "D-3" are a 16-pin glomper clips that each (identical)
>have jumpers between pins 3, 6, 8, 10, & 13.
>Part "E-3" is a 16-pin glomper clips that have a jumper between pins 1 & 7.
>
>These four parts are used with KKs docs on using the Sig Analyzer on the
>8080 boards and go on the corresponding IC (IC B-3, D-3, and E-3).
>
>Hope this helps!
>
>John :-#)#
>_______________________________________________
>Techtoolslist mailing list
>Techtoolslist@flippers.com
>http://seven.pairlist.net/mailman/listinfo/techtoolslist
>FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment
>Archive site: http://seven.pairlist.net/pipermail/techtoolslist/

Big help Thanks!

So on the EE Module all the pins feed through including the ones jumpered ?
I ask because pin 19 would be pulled low by clip E3 and it is an output from CPU

Clip E3 would cause the data bus direction to go output only (which is OK for the
Midway 8080 board) and clip B3, D3 would set the 8080 to execute NOP's

Thanks

_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment
Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
Received on Fri Feb 22 21:38:34 2013