Re: 6800 to 6502 pod combo ROM?

I went back and double checked my work on cut traces and jumpers and didn't see any errors.  I replaced the 6800 with a 6502a, and tied pin 19 to VCC. 

Can I use the original ROM in the 6800 POD?  If so, is it more than just tying pin 19 to VCC?

Thanks again!

On Sunday, December 29, 2013 7:27 PM, Rodger Boots <rlboots2@gmail.com> wrote:
 
6502P would be 1MHz in a plastic case.
6502A is a 2 MHz part (needed especially for vector games).

On Dec 29, 2013 6:53 PM, "Troxelone" <troxelone@yahoo.com> wrote:

> Is there a difference between a 6502a and a 6502p? I took a 6502p out of
> my working Centipede PCB and put it in the pod.
>
>
>
> > On Dec 29, 2013, at 6:32 PM, Rodger Boots <rlboots2@gmail.com> wrote:
> >
> > REALLY stupid question, but you did also replace the 6800 with a 6502.
> _______________________________________________
> Techtoolslist mailing list
> Techtoolslist@flippers.com
> http://seven.pairlist.net/mailman/listinfo/techtoolslist
> FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment
> Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
>
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment
Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment
Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
Received on Thu Jan 2 15:28:15 2014