Matt!
Be careful here, 30KV is the bottom end for starting to produce XRAYs!
Disconnect the filament in the tube until you resolve this...Then measure
the across the regulator with an ohmmeter, I suspect it is shorted out
somehow, perhaps a solder blob...
John :-#)#
At 02:36 PM 8/8/99 -0700, you wrote:
>Actually it's a monitor problem.
>
>I was working on the high voltage PCB by putting in a Zannen cap kit. I
>followed the instructions REALLY carefully. When I put the monitor in - I
>first went to adjust the high voltage to a nice 19.5 KV at the anode on
>the crt - instead I'm getting 30Kv and I really can't adjust it too much.
>The other thing is - I plugged the board in to to see if any picture would
>at least show up. The game works, just no picture whatsoever.
>
>Any ideas?
>
>
>Matt
John's Jukes Ltd. 2343 Main St., Vancouver, BC, Canada V5T 3C9
Call (604)872-5757 or Fax 872-2010 (Pinballs, Jukes, Video Games)
http://www.flippers.com
"Old pinballers never die, they just flip out."
Received on Sun Aug 8 21:21:54 1999
This archive was generated by hypermail 2.1.8 : Thu Jul 31 2003 - 23:00:59 EDT