> I use a simple solution for the problem of damaged fingers on PC boards, I
> solder on an extension finger board, thus giving a totally fresh set of
> finger pads for the edge connector to grab onto
The simplest way to do this is to get a female solder-tail edge connector
and solder the tails onto the original edge connector and then put a
fingerboard in the female side. If the problem happens again, you have a
disposable edge connector that can simply be replaced (new fingerboard).
Received on Sun Oct 24 19:21:52 1999
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:32:47 EDT