> << After reading MK's article, I restored the board to it's
> original condition with these mods in place. I just finished testing it
> and it works! Unfortunately after a couple of minutes the picture
> begins to fade out of focus. Any ideas? >>
>
> Make sure your focus wire is soldered securely to the board, this often
> develops a bad joint. Also, try cleaning the focus pot. Check for any bad
> solder joints around your HVT and focus assembly.
>
> MK
I just checked the board. KUDOS go to the master, Michael Kelley! One
of the wires connected to the focus/brightness board was completely
broken, but I didn't notice since it was covered by the insulated rubber
boot on the end of the wire.
Thanks MK!
Noel
Received on Fri Nov 19 23:18:05 1999
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:32:29 EDT