RE: Gravitar CPOs - Last Minute Jitters

On my gravitar the gap between the overlay and the bottom edge is 1/16"
And the bottom of the yellow line is 2 11/16" from the bottom. (my yellow
line is 2 5/8" from the edge of the overlay + the 1/16" to the edge of the
CP)

-jeff

-----Original Message-----
From: acmech@erols.com [mailto:acmech@erols.com]
Sent: Tuesday, November 30, 1999 11:35 PM
To: vectorlist@lists.cc.utexas.edu
Subject: Re: Gravitar CPOs - Last Minute Jitters

I took a look at my Gravitar and the overlay is set back from the bottom
edge
where the hinge is located exactly 1/8".

Dan

On Tue, 30 Nov 1999 23:00:56 -0500, you wrote:

>With the Gravitar CPO I can't do a test fit to assure the sizing accuracy
of
>the NOS CPO, so I need your help. Can anyone tell me if the original CPO
>reaches *exactly* to the bottom edge of the CP? If not, *exactly* how far
is
>it off by? And even better reference would be if someone could measure from
>the bottom edge of the CP to an easy reference point on the CPO, such as
the
>bottom of the outside yellow border. I know this would be difficult to do
>accurately, but perhaps with a cloth tape measure (like those used in
>sewing) or some other flexible scale would be great.
Received on Tue Nov 30 23:16:21 1999