Re: Gravitar CPOs - Last Minute Jitters

Ok, here's my compromise:

On my NOS CPO the yellow line is 2 9/16" from the bottom edge. Adding Dan's
1/8" gives me Jeff's 2 11/16".

Perfect for both! ;)

Note that even if it is off by 1/16" it is an insignificant and unnoticeable
amount of variation for the installed CPO. There is no "critical" alingment
in the graphics.

Thanks!
-roy-

----- Original Message -----
From: jeff hendrix <jhendrix@Quark.Com>
To: <vectorlist@lists.cc.utexas.edu>
Sent: Wednesday, December 01, 1999 12:15 AM
Subject: RE: Gravitar CPOs - Last Minute Jitters

> On my gravitar the gap between the overlay and the bottom edge is 1/16"
> And the bottom of the yellow line is 2 11/16" from the bottom. (my yellow
> line is 2 5/8" from the edge of the overlay + the 1/16" to the edge of the
> CP)
>
> -jeff
>
> -----Original Message-----
> From: acmech@erols.com [mailto:acmech@erols.com]
> Sent: Tuesday, November 30, 1999 11:35 PM
> To: vectorlist@lists.cc.utexas.edu
> Subject: Re: Gravitar CPOs - Last Minute Jitters
>
>
> I took a look at my Gravitar and the overlay is set back from the bottom
> edge
> where the hinge is located exactly 1/8".
>
> Dan
>
> On Tue, 30 Nov 1999 23:00:56 -0500, you wrote:
>
> >With the Gravitar CPO I can't do a test fit to assure the sizing accuracy
> of
> >the NOS CPO, so I need your help. Can anyone tell me if the original CPO
> >reaches *exactly* to the bottom edge of the CP? If not, *exactly* how far
> is
> >it off by? And even better reference would be if someone could measure
from
> >the bottom edge of the CP to an easy reference point on the CPO, such as
> the
> >bottom of the outside yellow border. I know this would be difficult to do
> >accurately, but perhaps with a cloth tape measure (like those used in
> >sewing) or some other flexible scale would be great.
>
Received on Wed Dec 1 06:05:03 1999