Re: Battlezone question(s)

>Connections are an excellent place to start as there was quite a bit of
>struggle getting the connector reseated. I was making certain that each
>chip was reinserted in the same orientation that I removed it, but this
>begs the question - which is the correct orientation for the chip? I
>don't see a "pin 1" designation on the chip, nor do I see one marked on
>the board.

There is usually a "U" shaped marking on one end of the socket silk screened
onto the board. That tells you which end pin 1 goes.

You should find a dot, indentation, or something physically different on the
end that pin 1 resides. Look carefully to detect the marking.

Good luck!
Joel-
Received on Tue Dec 21 08:46:45 1999