I did not base the shafts off of an original roller, so I have no idea if
they are the same or not. I would imagine that they are not. I based the
clearances for the bearings off of a Centipede shaft, but the rest of the
dimensions were driven by the model in assembly mode.
I can make prints of the original roller shafts if someone wants to mail me
detailed dimensions.
The roller insert, the actual green nylon roller, is the same as a the
original, it's actually the dimensions that were used to drive the rest of
the model.
James
-----Original Message-----
From: Christopher X. Candreva [mailto:chris@westnet.com]
Sent: Friday, March 03, 2000 2:50 PM
To: vectorlist@synthcom.com
Subject: Re: VECTOR: Dedicated MH Roller Replacement - Finished.
On Fri, 3 Mar 2000, Mark E Davidson wrote:
> demand for the whole thing? Hands please. Im working on just rollers
By rollers, do you mean the big green thing, or the 2 steel shafts ?
Are the shafts on these repro's the same as the original ? If so, and a
bunch of these are going to be made, perhaps some extra shafts would be a
good idea, for people who's original controllers need new shafts (ie -- me)
.
==========================================================
Chris Candreva -- chris@westnet.com -- (914) 967-7816
WestNet Internet Services of Westchester
http://www.westnet.com/
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Fri Mar 3 15:29:01 2000
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:31:57 EDT