Re: WG6100 jitters

Are the jitters all over the screen? Or are they isolated in a particular
region? If you search the archives, i have posted in the past about some
boxy capacitors that when removed, got rid of my Tempest jitters. They
were pulled by Wells Gardner for no apparent reason between the second and
third revision of the monitors and were not documented in Woodcock's
article (although he knows about them and plans to add them to the next
revision of the doc). With that said, I don't know the locations off the
top of my head.. Maybe someone can look it up for you.

Fwiw, my problem consisted of jitters just right of center. It was a
isolated to about 3 inches.

Jon

At 10:14 PM 5/13/2000 +0200, you wrote:
>Hello Crew,
>
>I am having a small problem with my WG6100 Tempest monitor: the screen jitters
>in the X direction (mounted in the cabinet this becomes the y direction).
>
>The trusty o'scope shows a DC negative offset of about 2 volts at the
>output of
>the X amplifier. On this level a high frequency noise is added which shows
>up as
>jerky vectors like this:
>
>_____/\__/\____ (should be _____________ )
>
>This effect shows op on both negative and positive side of the amplifier. (the
>screen jitters both at the most upper as lower side, but it is always positive
>going as in the example (ie. it is really DC offset noise, the amplitude is
>always constant).
>
>-I have resoldered the whole X amp (actually the whole defl. board)
>-I have made sure the power supply outputs are nice and flat
>-I think there are no wirewound resistors because they are the same at the
>Y amp
>(and shouldn't that cause amplitude noise?)
>
>Can anybody give me a clue here, like which parts can cause the DC offset
>of the
>amplifier to behave like this?
>
>any help is greatly appreciated because my analog knowledge seizes here... :(
>
>Cya !
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Sun May 14 18:12:33 2000