Hey Guys,
I have a quick question, on my defection board I'm getting the correct
reading on the low voltage power supply +27.7 -27.7 but on the other end of
diode 105 (which goes to P100 and others) reads +11.3 it should be -27.7. I
also replaced, checked and capped every component from the high voltage to
the chasse transistors. I know it's not the high voltage section because I
swapped a know good one and still have the same problem. At this point I 'm
stuck I've been working on this for two months and have looked at every
place on the net that has dealt with vector monitors, but to not avail...
p.s. Also since I'm not getting the corect -27, the high voltage does not
come up and the spot killer light stays on...
Thanx
justin monast
http://www.naughtydog.com
mailto:jmonast@naughtydog.com
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Fri May 19 19:17:40 2000
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:32:16 EDT