Re: Omega Race board repair...anyone?

In a message dated 7/18/00 3:31:23 PM Eastern Daylight Time, jrr@flippers.com
writes:

<< Any other suggestions while I'm checking this little guy out? >>

The "Valid Power On Detect" in Omega Race is VERY similar to those found in
Stern MPU 200's and Bally -35 pinball mpu's. When there is corrosion damage,
this curcuit is often affected. You might want to check Clay's site (not
"our" Clay on the Vectorlist, but this Clay is REALLY into pinball) :

http://www.marvin3m.com/fix.htm

Check out the section about repairing corrosion damage on Bally/Stern MPU's.
This should get you started on the Omega race board repair. I rtecently
repaired the boardset in my Omega Race CT, and being familiar with pinball
MPU repair sure helped!

MK

TTYL
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Wed Jul 19 01:03:11 2000