RE: WG V2000 Question

WG V2000 QuestionWell, one way would be to put a unity gain inverting op-amp
on the x axis drive.

Here is a circuit:
http://www.prolectron.com/elect/

Do the inverting op-amp for your circuit and set resistors around 1-10K and
arranged for unity gain. Bypass power supply with 0.1uF

Or you could just swap the yoke leads for that axis :-) HA HA.
-J
  -----Original Message-----
  From: owner-vectorlist@synthcom.com
[mailto:owner-vectorlist@synthcom.com]On Behalf Of Shaffelburg, Paul
  Sent: Friday, October 13, 2000 8:54 AM
  To: 'vectorlist@synthcom.com'
  Subject: VECTOR: WG V2000 Question

  I have a Wells Gardner V2000 that was removed from a cockpit Omega Race.
I hooked it up in my Asteroids cabinet, but the picture is reversed to
accommodate the mirror effect of the OR cabinet. Any ideas on how to
correct it? It doesn't seem to be at the board level, because I have had it
plugged into three working Asteroids board sets, and they all were reversed
on this monitor, and not in my friends Asteroids cocktail.

  Thanks!

  -Paul

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Fri Oct 13 09:53:11 2000