More on my WG 6100 problems

Hello group,

At the advice of somebody who knows more about this than me, it was
suggested that F600 was blowing fuses because of a short in the chassis
transistors or the yoke had a short. None of the transistors were
shorted, so I unplugged P701 (the connector to the yoke...)

Sure enough, F600 did not blow. However, C902 on the HV board make a very
large "POP" and proceeded to smoke.

How does one go about testing a yoke for shorts? And would C902 blow if
the yoke was not hooked up? Or is that indicative of another problem?

Thanks,

Pat

-- 
       "You are not a beautiful and unique snowflake!" - Tyler Durden

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Fri Nov 3 01:22:11 2000