Re: Star Wars PSU and newbie advice ....

In a message dated 11/21/00 2:48:04 PM Eastern Standard Time,
robotron@ntlworld.com writes:

<< Hi ....
 
 First the introduction ....
 
 I've collected quite a lot of raster stuff over the last two years,
 particularly I've become quite an accomplished techie on the Williams
 Raster games (such as Defender and Robotron) ... however until now I've
 kept away from Vector games!
 
 As of Saturday I'm the proud owner of a Star Wars Cockpit game. Its been
 in a barn for 12 years and is in pretty good condition considering where
 its been stored. The game has its controller, boardset, ARII and all the
 parts of its 25" Amplifone monitor (the HV boards coil is red and is serial
 number XY-18250). It does not however have the PSU and transformer
 assembly that sit in the bottom of the cab.
 
 Firstly, what should there be in the bottom. >>

You need an Atari color Vector transformer assembly/power supply A037396-xx.
I'm guessing the bolts are your brackets to mount the power supply. If you
look in a SW manual, you'll see what the assembly looks like.

<A
HREF="http://www.gamearchive.com/video/manufacturer/atari/vector/onlinemanuals

/starwars_op_manual.pdf">
http://www.gamearchive.com/video/manufacturer/atari/vector/onlinemanuals/starw

ars_op_manual.pdf</A>

Perhaps someone on this list has one you can buy or trade for??

Thanks again to Jess for the Gamearchive...
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Wed Nov 22 00:33:35 2000