Re: If you could wish for anything....

If I could wish for anything, I would wish to be Big!...

No seriously, My vote goes to A replacement G08 deflection board

-=Mark=-

Rodger Boots wrote:

>I'm trying to design too much stuff and resulting in getting nothing
>done. So let's see what interest there is in any of this stuff.
>
>Test monitor. A small (12" or under) black and white vector monitor
>that couldn't be damaged by bad boards. I have a small number of vector
>yokes that would fit a 20 mm neck b&w tube. A bullet proof deflection
>board is easy enough for a small monitor. I also have 300+ Sony
>flybacks laying around that could power a small tube. I even have some
>5" tubes, but that may be too small. Any ideas if this is a worthwhile
>project to pursue and what size tube would be ideal.
>
>Replacement for Keltron. Kind of goes back to the 300+ Sony flybacks
>above. Pursue it or drop it?
>
>Replacement for 19 KV vector high voltage power supplies. Supposedly
>everyone is about to announce this one. Mine is based on the flyback
>used in the WG K7000. Turns out there is a company that makes flybacks
>(HR Diemen) that makes a replacement for the K7000 flyback. For all I
>know they might even be the OEM for them. MCM Electronics sells the HR
>part at a decent price. The advantages to using this particular part,
>as I see it, are 1) availability, 2) price, 3) already know it is likely
>to work with our tubes, 4) has a built-in HV bleeder to discharge the
>CRT, 5) can be it's own isolation transformer if run off the power
>line. Should I keep running with this or let others come out with
>competing products and hope they work?
>
>Entire vector monitor. I presently have possible CRT/yoke combinations
>tracked down for 19", 25", 27", and 33". I think I also have an
>indestructible deflection board design. Cut bait or run? What's the
>most likely to be useful sizes?
>
>Replacement G08 deflection board. Same indestructible design I
>mentioned above. Do it or chew it?
>
>Replacement for Fluke 9010A that interfaces a Fluke pod to a computer.
>Any need for it?
>
>Universal pod for Fluke 9010A. One pod with interchangeable cartridges
>to handle just about any processor used in arcade games, including a few
>that Fluke never supported. Would probably kill the market for Fluke
>pods (great...after I just bought a bunch of them...). Any interest?
>
>Any interest in anyone helping to build any of this?
>
>Should I just go back to bed?
>
>I obviously can't do all of these simultaneously, I have neither that
>kind of time or resources to do it. But I'd like to get a feel for what
>is most likely to be useful. What is most likely to sell. (What is
>most likely to pay for doing the rest of it).
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to vectorlist-owner@synthcom.com.
>

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Sun Jun 23 20:03:34 2002