Hi,
Thanks. I tend to underestimate how much I can figure out on my own if I
stare at the schematics long enough. I checked continuity thru the whole
wiring harness, then checked voltages at the monitor plug. As it turns out,
two of the wires that lead back from the monitor harness to the 60-0-60V had
been switched, and one of the 60s was where the ground should have been. (7
and 8 had been switched.) Switched them around and problem fixed. BTW, the
wire colors shown in my BZ schematics don't match any of my three cabs....
Lewis
> -----Original Message-----
> From: owner-vectorlist@synthcom.com
> [mailto:owner-vectorlist@synthcom.com]On Behalf Of Andy Welburn
> Sent: Monday, September 10, 2001 5:34 AM
> To: vectorlist@synthcom.com
> Subject: Re: VECTOR: Battlezone cabaret monitor harness question
>
>
> do you have the manuals/schematics? they have all this info in them :)
>
> Andy
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Tue Sep 11 21:10:16 2001
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:33:41 EDT