Re: WGK6100 Trace Lines Visible

Check the R G B bias controls on the neck board, these can be turned too
high to the point of not being able to be turned off.
----- Original Message -----
From: "Mark Jenison" <jenison@enteract.com>
To: <vectorlist@synthcom.com>
Sent: Wednesday, October 03, 2001 5:12 PM
Subject: Re: VECTOR: WGK6100 Trace Lines Visible

>
> > Greetings all;
> >
> > I have a WGK6100 monitor in one of my Star Wars & no matter how bright
or
> > dim I adjust it, the vector trace lines are showing.
> > I have a capkit on order & will be installing that as soon as it
arrives.
> > My question is, In your far wiser opinions, should that correct the
problem
> > or should I be prepared to look further? Or should I not worry about it
till
> > after the capkit?
>
> My guess is that adjusting the pot that is inside the HV cage will get rid
> of your retrace lines. Even so, cap it as well (the cap kit will include
> a replacement for this pot as well).
>
> > I have run an extention over to my other StarWars with an Amplifone
monitor
> > & it doesnt exhibit these symptoms
> > Thanks for any & all help
> > Randy
> >
>
> --------------------------------------------------------------------------
-
> > ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
> > ** message body to vectorlist-request@synthcom.com. Please direct other
> > ** questions, comments, or problems to neil@synthcom.com.
> >
>
> --
> ______ ___ _____ __
> Mark Jenison / __/ / / / |/ / / |/ //|/|/|_______________
> jenison@ / __/ /_/ / / / | // | / |__ __/ _ /__ \
> enteract.com /___/___/_/_//_/_/_/|_//__|/__| / / / // / /
> M.A.R.S. - www.enteract.com/~jenison/mars /_/|_| /_/ /____/_/|_|
>
>
> --------------------------------------------------------------------------
-
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Wed Oct 3 20:18:26 2001