Re: Amplifone DEFLECTION QUESTION

i put my hand on the x-out or the y-out test point and then put the other
 hand on the sound out test point if you hare vector noise then its going
ps you can user a 10k res will all so do

>I never had this problem before until I blew some power transistors. I dont
>believe its the yoke it worked fine before all that. I dont have access to a
>scope so cant check with that.
>Dan Piraino
>
>Chris Starr wrote:
>
>> A yoke problem perhaps? But that's worst case.
>> What does the signal look like for the video board on an oscilloscope?
>>
>> sorry - an oscilloscope that does x/y input.
>>
>> ----- Original Message -----
>> From: "Daniel Piraino" <dpiraino@twcny.rr.com>
>> To: <vectorlist@synthcom.com>
>> Sent: Friday, October 05, 2001 12:22 AM
>> Subject: VECTOR: Amplifone DEFLECTION QUESTION
>>
>> >
>> > I have been working on an Amplifone board that I have gotten to the point
>> of running
>> > without blowing transistors. I found the culprit and fixed it but there is
>> a problem
>> > im not sure of. The screen is sqewd. To explain what it looks like it
>> would be like
>> > if you took the top left corner of the screen and pulled it to the middle
>> of the
>> > screen. Nothing is draw to the top of the screen or to the left side of
>> the screen.
>> > Everything is being drawn to the bottom right of the screen. I was
>> wondering if it
>> > could be a capacitor that went bad. I havent checked them yet but I will.
>> If you
>> > understand what Im saying and have an idea let me know.
>> > Thanks,
>> > Dan Piraino
>> >
>> > --------------------------------------------------------------------------
>> -
>> > ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
>> the
>> > ** message body to vectorlist-request@synthcom.com. Please direct other
>> > ** questions, comments, or problems to neil@synthcom.com.
>>
>> ---------------------------------------------------------------------------
>> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>> ** message body to vectorlist-request@synthcom.com. Please direct other
>> ** questions, comments, or problems to neil@synthcom.com.
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.
>
>

__________________________________________________
Advertise with ZFREE - to find out more click below
http://www.zfree.co.nz/about-us/advert.html
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Thu Oct 4 23:54:28 2001