Re: Self Test with Tempest multigame

Whatever the problem was went away when I reseated the multigame parts and
disconnected/reconnected the mathbox board connector. It didn't work
right away but after going into the multigame menu and selecting version 3,
it seems to work fine. I'm sure the problem will come back but I'll wait
until dies more permanently.

-Werner

At 11:33 AM 10/22/2001 -0400, you wrote:
>On Mon, 22 Oct 2001, Werner Sharp wrote:
>
> > disable the watchdog and see if I can get into test mode. I'm guessing the
> > mathbox board is having problems (upside down screen) plus Clay's menu
> > works fine but the game itself doesn't run.
>
>As far as I can tell, a working Tempest board will draw an upside-down logo
>very quickly on reset, blank, then go in to attaract mode. Normally, you
>don't see the upside down logo since the monitor is warming up.
>
>I'm having an occasional problem similar problem on mine that I think is a
>bad or loose pokey. Again, when I move the machine to work on it, whatever
>is loose is shaken into place, and it starts working again for a few weeks.
>
>-Chris
>
>==========================================================
>Chris Candreva -- chris@westnet.com -- (914) 967-7816
>WestNet Internet Services of Westchester
>http://www.westnet.com/
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Mon Oct 22 10:05:11 2001