From what I remember, the Amplifone tube actually has the "standard" end cap. The WG6100 has the funky one that usually needs replacing when swapping tubes. Can anyone verify this? I have an Amplifone upstairs here at work, so I could go have a look. I don't have anything to compare it to though :)
Jon
At 12:18 PM 11/9/2001 -0500, you wrote:
>Thanks to Noel for his kind response. I should have stated things more
>clearly - I am replacing the entire WG 6100 monitor in my Gravitar cabinet
>with an Amplifone. I have all components (WinTroned HV unit, Delflection
>board, Ampifone mounting brackets, and Amplifone yoke) except for the tube.
> I just ordered the 19VLUP22 from Richardson. I'm guessing I will have to
>replace the base cap of the 19VLUP22 in order for it to work with the
>Amplifone, correct? Also, Richardson says these tubes are "rebuilt".
>Is there still a chance of phospher burn on a rebuilt tube? Also, any idea
>where I might get a base cap for the 19VLUP22 that will work with the
>Amplifone? I don't have any extra old tubes laying around here. Perhaps
>someone on the list has one to sell??
>
>Thanks Very Much,
>Michael Kelley
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Fri Nov 9 10:51:58 2001
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:33:45 EDT