Re: vector: starwar dead :(

thanks, i tryed it last night and it when for 10mins then the agv started to play
up.
so i'm going to put in a s/mode p-supply... and reseat the chip and i think that
will be it
I hope :P

>would have to agree with John..
>
>classic symptom if the coin mechs are clicking over continuoesly, there
>isn't enough juice gettng the the main board which indicates a bad connector
>eventually knocking the voltage below a certain level, !!!!or the psu is on its

>way out!!!!!!!!
>
>i think its somethign to do with the transistors on the main board used for
>clicking the coin counter over not being able to keep the junction
>open/closed because of an out-of-spec voltage and they break down, then kick
>in then break down, then click in, this just rolls them coin counters over
>:)
>
>Andy
>----- Original Message -----
>From: "John Robertson" <jrr@flippers.com>
>To: <vectorlist@synthcom.com>
>Sent: Monday, December 17, 2001 5:46 AM
>Subject: Re: VECTOR: vector: starwar dead :(
>
>
>> If no self test, then check that you have +5VDC at the MPU test points...
>>
>> John:-#)#
>>
>> At 05:49 PM 12/17/01 +1200, you wrote:
>>
>> >my starwars die last night it's reseting and the coin counter is clicking
>> >the sound
>> >broad
>> >is doing all strang things. my tempest did this and in the end it was
>> >just the ram.
>> >
>> >
>> >has any one had/fix this?? any help would do... "don't tell me to (dis
>the
>> >dog)"
>> >:P
>> >
>> >tar
>> >
>>
>> --------------------------------------------------------------------------
>-
>> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
>the
>> ** message body to vectorlist-request@synthcom.com. Please direct other
>> ** questions, comments, or problems to neil@synthcom.com.
>>
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.
>
>

__________________________________________________
Advertise with ZFREE - to find out more click below
http://www.zfree.co.nz/about-us/advert.html
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Tue Dec 18 23:33:28 2001