Re: WGK6100 Retrace lines wont go away

The screen voltage is not too high to measure, you can check it with a
voltmeter set to 1,000 VDC range. Does it vary steadily? If not then either
a connection problem or the control is defective.

John :-#)#

At 09:42 PM 31/12/2001 -0600, you wrote:
>Here's something to try. It happened to me long ago.
>
>Check BEHIND the focus/screen pot assembly and see if the wires connected to
>those pots might be loose. They should have rubber caps around them but
>those slide back easily. I once had a wire come loose underneath that cap
>where I couldn't obviously see it.
>
>These wires are actually connected via crimp-on connectors. The screen and
>focus pots have posts that come out the back.
>
>HTH,
>
>Matt J. McCullar
>
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Mon Dec 31 20:41:14 2001