Re: WGK6100 Retrace lines wont go away

I checked the voltage at the back of the screen adjustment on the good HV.
Came to around 392 and varied but stayed at that range.
I then swapped in the bad HV, the voltage readings started at around 220 and
dropped steadily. It was about 180 when I turned off the machine, but it
never rose, only fell

The Screen & Focus connections were good, I pulled & reseated them to no
avail.

Thanks for the tips, keep em coming if ya got em!
Randy

----- Original Message -----
From: "John Robertson" <jrr@flippers.com>
To: <vectorlist@synthcom.com>
Sent: Monday, December 31, 2001 11:18 PM
Subject: Re: VECTOR: WGK6100 Retrace lines wont go away

> The screen voltage is not too high to measure, you can check it with a
> voltmeter set to 1,000 VDC range. Does it vary steadily? If not then
either
> a connection problem or the control is defective.
>
> John :-#)#
>
> At 09:42 PM 31/12/2001 -0600, you wrote:
> >Here's something to try. It happened to me long ago.
> >
> >Check BEHIND the focus/screen pot assembly and see if the wires connected
to
> >those pots might be loose. They should have rubber caps around them but
> >those slide back easily. I once had a wire come loose underneath that
cap
> >where I couldn't obviously see it.
> >
> >These wires are actually connected via crimp-on connectors. The screen
and
> >focus pots have posts that come out the back.
> >
> >HTH,
> >
> >Matt J. McCullar
> >
> >
>
>---------------------------------------------------------------------------
> >** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
> >** message body to vectorlist-request@synthcom.com. Please direct other
> >** questions, comments, or problems to neil@synthcom.com.
>
> --------------------------------------------------------------------------
-
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Tue Jan 1 19:36:27 2002