RE: Red Baron 19V2000 question

Thanks, Chris.
Part of the problem is that I'm not sure where the problem lies. I started
out thinking it was a monitor problem, because it came up the same way with
two different main boards. But the monitor works fine on a known-good BZ
game. So either I've got two main boards with the exact same problem (seems
unlikely), or the problem lies elsewhere. I've also tried two different R/A
II boards and two different power supply assemblies; same problem.
So now I'm thinking it has to be: A) the wiring harness/edge connectors; B)
the aux board. As far as I can tell, there's no way a shrunken picture
problem could be caused by the aux board, so I've got new edge connectors on
the way from Bob Roberts. I'll rebuild the wiring harness and see where that
gets me. If it doesn't work, you'll all be hearing from me again ;)
Lewis

-----Original Message-----
From: owner-vectorlist@synthcom.com
[mailto:owner-vectorlist@synthcom.com]On Behalf Of Christopher X.
Candreva
Sent: Monday, January 28, 2002 11:39 AM
To: vectorlist@synthcom.com
Subject: Re: VECTOR: Red Baron 19V2000 question

On Tue, 22 Jan 2002, Lewis Mills wrote:

> noise decrease, and the image shrinks from top and bottom into a
horizontal
> band in the center 1/4 of the screen. Width is OK, but height is not. Has
> anyone seen this one? None of the case-mounted power transistors on the
> monitor are getting hot.
> Pointers, anyone?

www.radioshack.com :-)

Get a can af componant cooler, start spraying things to cool them down until
it works again.

==========================================================
Chris Candreva -- chris@westnet.com -- (914) 967-7816
WestNet Internet Services of Westchester
http://www.westnet.com/

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Tue Jan 29 13:38:29 2002