Re: Amplifone that won't focus

You might try checking the solder joints where the wires connect to the
focus/brightness adjustment block. These are notorious for breaking. You
often can't tell they're broken since the insulating boot holds them in
place.

Noel

> Is the voltage applied to the CRT (high voltage) correct?
>
>
> - Matt
>
>
> At 01:08 AM 2/5/2002 -0800, you wrote:
>>I have an amplifone monitor that I recapped and got working. It has
>>the wintron transformer in it. It was working fine for a while. Then
>>it went out. I got it working again. But it's hard to focus. Has
>>anyone run into this problem before?
>>
>>
>>Matt
>>
>>--------------------------------------------------------------------------
-
>>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
>>the ** message body to vectorlist-request@synthcom.com. Please direct
>>other ** questions, comments, or problems to neil@synthcom.com.
>
>
>
> Matthew Sell
> Programmer
> On Time Support, Inc.
> www.ontimesupport.com
> (281) 296-6066
>
> Join the Metrology Software discussion group METLIST!
> http://www.ontimesupport.com/cgi-bin/mojo/mojo.cgi
>
>
> "One World, One Web, One Program" - Microsoft Promotional Ad
> "Ein Volk, Ein Reich, Ein Fuhrer" - Adolf Hitler
>
> Many thanks for this tagline to a fellow RGVAC'er...
>
> --------------------------------------------------------------------------
-
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
> the ** message body to vectorlist-request@synthcom.com. Please direct
> other ** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Tue Feb 5 11:38:44 2002