The MC1 is off of a known good board.
The HV transformer rings fine..
Thanks,
Joe
MKDUD@aol.com wrote:
> In a message dated 3/9/2002 3:46:26 AM Eastern Standard Time,
> joe.bachmann@newmail.net writes:
>
> << But, that's not it... I have replaced the regs 4 times... It's not
> helping, the
> diodes are good.
>
> I am getting 0 at the +24.
>
> My -24 is good.
> My +30s are good.
>
> The BU is good. The 555 circuit is good.
> The 2n3904s are good
> MC1 and the small xformer are good
> The MPSU07 is good.
> The SCR is good.
> The caps are good.
> The HV diode is good.
>
> Any ideas? >>
>
> Have you rang out the HV trans at all? How did you test the MC1? I didn't
> know there was a reliable way to test MC1, but if you're losing regs enough
> to replace them 4 times, it might be "the damn red can..."
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Sun Mar 10 11:41:23 2002
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:33:55 EDT