The 1 ohm resistor must be present to protect the filament of the picture
tube. Just make sure there is one in circuit.
The RGB is not required if you can bypass the brightness control. No reason
not to leave it in place, I was just trying to simplify the thing. I
haven't done a second one as there has been no need so far.
John :-#)#
At 11:47 AM 13/07/2002 -0500, Gregg Woodcock wrote:
>I have a few questions since the steps are worded ambiguously.
>
>He says to "make sure" there is a 1 ohm resistor on the heater. Does that
>mean we MUST add one or maybe there is already one there and we should just
>check. I assume he means "add one" instead of "make sure".
>
>It appears that initially he left the RBG board in but later modified the
>instructions to remove the RBG board but didn't really complete the text.
>It appears that the schematic is complete and that there are some
>caps/resistors to be inserted to bypass the RGB board, right? If you have
>SUCCESSFULLY done this mod, please fill in these gaps for me; I want to try
>this tonight!
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Sat Jul 13 10:32:57 2002
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:34:04 EDT