On Mon, 14 Apr 2003, John Robertson wrote:
> I am now adding a jumper wire from the monitor mother board that will go to
> the monitor chassis, and then ground the chassis to the power supply with a
> heavy wire, and run a separate wire from the same point to the logic board
> ground plane (solder to the board if the logic boards are not connected to
> the cage).
When I added a gound wire from my monitor chassis to the card cage chassis,
I started getting incredible distorion on my monitor. Are there specific
points that it is good to pick up the ground ?
I had to build a complete new power cable from the power supply to the card
cage, so I have brand new connectors on both sides. Is this sufficent for a
'fresh' ground from the PS to the cards ?
-Chris
==========================================================
Chris Candreva -- chris@westnet.com -- (914) 967-7816
WestNet Internet Services of Westchester
http://www.westnet.com/
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Tue Apr 15 08:04:05 2003
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:34:27 EDT