Using fluke 9010 on BZ in self test

I have a board which is giving me fits.On its own if I bring it up in test mode the test screen comes up just fine. When I put it into play mode I get a blank screen.

I hooked up the 9010 ran bus, ram, rom tests everything checks out fine.

But when I put the board into test mode with the pod connected it doesn't bring up the test screen.

Anyone had this problem? Any ideas on what might be happening?

Oh, also anyone know a good source of turned pin sockets? I want to put sockets on the pods to protect the pins.

David

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Fri May 9 07:57:09 2003