Re: Smaller CRT's

I think you all might be missing a point here, all using the same socket
adapter on a CRT tester means is that you CAN TEST THEM USING THE SAME
ADAPTER.

It does NOT mean the focus voltage range is the same.
It does NOT mean the high voltage requirements are the same.
It does NOT mean the deflection angle is the same.
It does NOT mean the mounting is the same.
It does NOT mean the X-ray protection is the same.
It does NOT mean the same yoke and convergence assemblies can be used.
It does NOT mean the dot pitch will be as good.

Other than that, they're identical.

Dave Langley wrote:

> At 08:41 am 13 05 2003, you wrote:
>
>> I was just thinking of some interesting ways of making my test bench
>> smaller because of my limited space. A little while ago I scanned in
>> the B&K CRT Setup Chart which not only makes a good cross-reference
>> guide, but also allows you to cross-over different sizes by looking
>> at the matching CRT adapters.
>> http://www.ionpool.net/arcade/tech/bk-rejuvenator-setup.pdf
>
>
> This sounds like a cool idea! So are you saying that if a a tube uses
> the same adaptor then the tubes are likely to be compatible?
>
> I have two Samsung A48KRD82X tubes that came from a WG 19K7302 and a
> Ducksan, both out of pin2k games they are listed as a type #23 the
> same as an Amplifones 19VJTP22. I've considered using them in vector
> applications since they are only about three years old and have NO
> burn-in.
>
> [Going a little OT here]
> I was also wondering ... later WG 19K7302's use an Orion A48JLL40X
> which is listed as a type #31. These must be compatible as the chasis
> has not changed, so I could also use these as an Amplifone cross.
>
>> So, a 19" amplifone CRT (19VLUP22) should be compatible with
>> anything using adapter #23 according to the Setup Chart right?
>
>
> BTW: the 19" Amplifone tube is 19VJTP22 (from the manual) or M48AAW00X
> and the 19VLUP22 is for the WG 6100 ... as you state later!
>
> Dave Langley
> www.robotron-2084.co.uk <http://www.robotron-2084.co.uk/>
>

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Tue May 13 12:51:28 2003