Re: Re:WG-6100 help PLEASE! ----Follow up

-----Original Message-----
From: dax@xmission.com
To: vectorlist@synthcom.com
Date: Fri, 16 May 2003 20:11:52 -0600
Subject: VECTOR: Re:WG-6100 help PLEASE! ----Follow up

>
> Sorry all for the multiple posts here.
> After doing some looking around on the pcb and also looking at Gregg Woodcocks
> most helpful bible on page 31, although it applies to R903 -> R101 it got me looking
> around and I found that R901 and R907 are supposed to be 2.2 ohm 2 watt but were
> 3.9 ohm 2 watt. These cages were hand-me-downs and I guess I should have looked
> closer at everything but then who would guess? I've replaced Q901,902,905 and
> 908. I also replaced Q900 and Q906 to be safe.
> Anyway, I'm still not too anxious to apply power until I get some input from the group
> so please, if anyone has any ideas, shout out.
> I'm sort of wondering if maybe the hv adjust (R918) may be too high? Where should
> it read? Would that have this effect?
>
>
> Many thanks to Gregg and anyone else who can help,
>
> -Dave

dont panic, i have both.

the 2.2R resisters are on the 'original?' P316 pcb,
and the 3.9R are used on the newer P329 series.
also, on my 329 the 3.9R resisters are 3w, not 2w.

it's just a mod to reduce maximum current flow i suspect.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Fri May 16 19:41:49 2003