Re: Tempest lines fading

Sounds like the focus is shifting on the monitor. Back when I used to
have Tempests I could get the same effect by adjusting focus. The key
there was to set focus for the best compromise.

Unless of course you're using different monitors on the two boards. But
if it's a common monitor you need to fix it there. Try setting focus to
thicken the horizontal lines a bit and see if you still have the
problem. I doubt it's the boards.

Joe wrote:

>I have two Tempest boards here in which the vectors fade in and out. On
>the one board, I notice it most on the horizontal vectors. They start
>off as a normal width, but will change to about half the width. When
>faded, zeros on the screen look more like ones. Do, a high score of
>1010101 would look like ||||||||||, but with VERY faint lines connecting
>the tops and bottoms.
>
>I've been concentrating on the DAC-08 area, but I feel I may be chasing
>a red herring here... I know this is not related to the aux board. Any
>suggestions?
>
>Thanks,
>JB
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@vectorlist.org. Please direct other
>** questions, comments, or problems to chris@westnet.com .
>
>
>
>

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@vectorlist.org. Please direct other
** questions, comments, or problems to chris@westnet.com .
Received on Tue Aug 26 14:16:40 2003