RE: G-05 power resistor tolerance?

Just use the 2.2... Those are fuseable resistors.

-----Original Message-----
From: owner-vectorlist@vectorlist.org [mailto:owner-vectorlist@vectorlist.org] On Behalf Of Archer
Sent: Wednesday, February 04, 2004 11:01 AM
To: vectorlist@vectorlist.org
Subject: RE: VECTOR: G-05 power resistor tolerance?

correction !

5pm mode just cut in . . the previous explanation still gives 2.2. DOH !
I'd not worry about it and just use 2.2 :)

-----Original Message-----
From: owner-vectorlist@vectorlist.org
[mailto:owner-vectorlist@vectorlist.org]On Behalf Of Dave Langley
Sent: 04 February 2004 12:28
To: Vector List
Subject: VECTOR: G-05 power resistor tolerance?

Hi all,

I have an untested G-05 805 that I would like to test but it has a few
parts missing from the deflection PCB, none of them are that hard to find
except I cannot find an exact replacement for one part: R720 - a 10W 2ohm
resistor.

All the UK based component suppliers that I use only seem to list 10W
resistors in the 2.2ohm range ... will this matter or is its value critical?

Any thoughts or opinions would be welcome!

Dave Langley
www.robotron-2084.co.uk

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com

---
Incoming mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.577 / Virus Database: 366 - Release Date: 2/3/2004
 
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.577 / Virus Database: 366 - Release Date: 2/3/2004
 
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com