> On Mon, 31 May 2004 22:52:35 -0500, you wrote:
>
> >So, even if a chip's tolerance is listed as +5.25V
> on it's data sheet, it
> >can still "survive" at the higher voltage?
Even though the TTL chips may survive, others might
not. Specifically, I'd check the bipolar proms. I
recently repaired a Black Widow that was accidentially
run at 7v (bad A/R II) and the only thing that I found
that had been affected were the bipolar proms. They
were all dead. I replaced thouse and everything was
up and running.
Good luck,
-Chris
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Tue Jun 1 08:26:54 2004
This archive was generated by hypermail 2.1.8 : Tue Jun 01 2004 - 14:50:00 EDT